Looking after your magnets
A magnet lives in the steamiest, greasiest room in the house and gets touched by everyone who walks past. That is what the protective film is for. Beyond an occasional wipe, there is very little to do.
- Step 1
Wipe with a damp cloth
Plain water on a soft cloth removes kitchen grease and fingerprints. Wipe in one direction and dry with the other side of the cloth.
- Step 2
Skip solvents and scourers
Spirit, acetone, bleach and abrasive pads attack the protective film rather than the dirt on it. Mild dish soap is the strongest thing a magnet ever needs.
- Step 3
Lift, do not slide
Pull a magnet straight off the door instead of dragging it across. Sliding traps grit between the magnet and the paint, which is what scratches fridges, not the magnet itself.
- Step 4
Store flat
Magnets not on the door go in the gift box they arrived in, stacked flat, print side to print side. Never roll them.
How long does the print last?
Years, in a normal kitchen. The colour comes from fine pigment inks rather than dye, which is the difference between a print that holds its tone for a decade and one that goes orange in a couple of summers. The clear non-glare film on top takes the steam, the splashes and the fingerprints so the photograph never does. What does shorten a print's life is hours of direct sunlight every day, so a magnet on a fridge standing in a south-facing window will fade sooner than the same magnet three feet away.
Which surfaces will a magnet stick to?
Anything ferrous: refrigerator doors, steel almirahs, metal cabinets, whiteboards, filing cabinets and most microwave and oven fronts. The whole back is a continuous 1 mm flexible magnetic sheet, so grip is spread over the full footprint instead of a strip in the middle, and nothing slides down the door over a week. Two surfaces it will not hold on: some premium stainless steel fridge fronts, which are non-magnetic despite looking like steel, and any plastic or laminate wrap. Test with any ordinary magnet before ordering if you are unsure.
Will it scratch or mark the fridge?
No. The back is smooth flexible rubber with no exposed metal, no glue and no hard edges, so it sits flush against paint or steel. The only way a magnet marks a door is if grit gets underneath and you then slide it, which is why the advice above is to lift rather than drag. Moving a magnet occasionally also stops the faint outline that any object leaves on a door it has covered for years.
Something arrived damaged or faded early
Send a photograph within 48 hours of delivery and we replace it. That covers transit damage and any print or finish defect. It does not cover a soft print caused by a low-resolution source photograph, which the builder warns about before checkout. Full terms are in the refund and replacement policy, and delivery timelines are in the shipping policy.